Range Rover Evoque: Suspending and resuming cruise control

Suspend cruise control with a single press of control (3).

To resume cruise control at the previous set speed, press control (2).

if the RES (2) should be used only if the driver is aware of the set speed and intends to return to it.
It is not recommended to resume set speed when a low gear is selected as excessive engine speeds will occur.

READ NEXT:

 Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed. - The brake pedal is pressed. - Speed falls below 30km/h (18mph). - Neutral, Park

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

 Stability control

SEE MORE:

 A-Pillar Trim Panel, B-Pillar Upper Trim Panel 5-Door

A-Pillar Trim Panel Removal NOTE: Removal steps in this procedure may contain installation details. 1. Torque: 6 Nm Installation 1. To install, reverse the removal procedure. B-Pillar Upper Trim Panel 5-Door Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. 3.

 Anti-Lock Control

Torque Specifications Anti-Lock Brake System (ABS) Module Removal CAUTIONS: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. Make sure that all openings are sealed. Use new blanking caps. NOTES: Removal steps in this procedure may contai

© 2011-2025 Copyright www.rrevoque.org