Range Rover Evoque: Tyre change
Valve stem seal, washer, nut,
valve core
and cap should be replaced at every tyre
change. Valve stem seal, washer and
nut must be replaced if valve retention
nut is loosened. Sensor units and nuts
must be refitted using correct torque
figures and associated profile. Damage
to the vehicle may result if these
precautions are not taken.
Any tyre changes must be carried out by a qualified technician. Great care must be taken during removal and refitting of tyres to avoid damaging the sensor.
READ NEXT:
Replacement sensor
Should the sensor require replacing, it should
be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a
running wheel in order to be recognised by the
system. The v
Tyre repair kit
If you are in any doubt
regarding your
ability to carry out the instructions,
contact your Dealer/Approved
Repairer before attempting the repair.
Your vehicle may not be equipped with a spare
SEE MORE:
Gradient release control (GRC)
With HDC activated, if the vehicle is stopped on
a slope using the foot brake, GRC will become
active (except in Terrain Response Sand
program). It operates in all gears and in neutral
position.
During a steep hill descent, when the foot brake
is released GRC will automatically hold brake
for
Suspension System - General Information
Coil Spring Suspension
Wheel Alignment Specification (All Markets) - Front
NOTE: All figures are with vehicle at 'Showroom' ride height - full
fluids, full tank of fuel, no occupants/luggage, tires
inflated to normal pressures
Wheel Alignment Specification (All Markets) - Rear
NOTE: All figures a
© 2011-2025 Copyright www.rrevoque.org
