Range Rover Evoque: Front Lower Arm
Removal
NOTES:
Some variation in the illustrations may occur, but the essential information is always correct.
Front wheel drive transmission illustrations shown, all wheel wheel drive transmission is similar.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3.
4.
Installation
1. CAUTION: Only tighten the nut and bolt finger tight at this stage.
2. CAUTION: Only tighten the nut and bolt finger tight at this stage.
3. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
Support weight of vehicle on a jack at the rear hub.
4. Torque: 175 Nm
5. Torque: 175 Nm
6. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
READ NEXT:
Rear Lower Arm AWD
Special Tool(s)
205-857
Remover, Halfshaft
Removal
CAUTION: LH illustration shown, RH is similar.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
Rear Stabilizer Bar
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure
Wheel Knuckle
Special Tool(s)
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshaf
SEE MORE:
Block Heater
Removal
1. Refer to: Cooling System Partial Draining, Filling and Bleeding
(303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
2. Refer to: Engine Undershield (501-02 Front End Body Panels,
Removal and Installation).
3. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and
Installat
Rocker Panel
Removal
NOTES:
The rocker panel is manufactured from mild steel.
Some of the butt joints must be MIG brazed due to the location of boron
reinforcements.
1. This procedure
identifies the
method for the
replacement of
the rocker
panel in full.
The graphic
and table
identify
possible
alternative
sec
