Range Rover Evoque: Locking wheel nuts
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wheel changing / Locking wheel nuts
Locking wheel nuts can be removed only by using the special adapter provided in the tool kit.
Note: When the vehicle is first supplied, the adapter may be stored in the glove compartment. It should be removed and stored in the tool kit as soon as possible.
Note: A code number is stamped onto the underside of the adapter. If a replacement adapter is required, you will be asked to quote this number. Ensure that the number is recorded and kept safe, but should not be kept with the vehicle.
READ NEXT:
Releasing locking wheel nuts
1. Insert the wheel nut adapter into the
locking wheel nut, ensuring that it is fully
engaged.
2. Locate the wheel brace over the adapter
and unscrew the wheel nut half a turn
counter clockwise.
Wheel changing
WARNING - THAT NO PERSON
SHOULD PLACE ANY PORTION OF
THEIR BODY UNDER A VEHICLE THAT
IS SUPPORTED BY A JACK.
Position the jack from the side of the
vehicle, in line with the appropriate
jacking
SEE MORE:
Transfer Case Rear
Seal
Special Tool(s)
100-012
Slide Hammer
205-871
Installer, Transfer Case Rear Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
Rear View Mirrors
Rear View Mirrors - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
DDM (driver door module)
Driver exterior mirror
Exterior mirror switches
Memory switches
Interior mirror (automatic dimming version shown)
PDM (passenger door
© 2011-2025 Copyright www.rrevoque.org
