Range Rover Evoque: Opening and closing the bonnet

Opening and closing the bonnet
Opening
1. Pull the bonnet release lever, located in the
left-hand front footwell.
2. Lift the bonnet safety catch lever, located
below the centre point of the bonnet, then
raise the bonnet.
Closing
Do not drive with the bonnet
retained
by the safety catch alone.
3. Lower the bonnet until the safety catch
engages. Using both hands, press the
bonnet down until the catches click. Check
that both catches are engaged by trying to
lift the front edge of the bonnet.
READ NEXT:
Fluids used in motor vehicles are poisonous
and should not be consumed or brought into
contact with open wounds.
For your own safety, always read and obey all
instructions printed on labels and co
Prolonged contact with engine oil may cause
serious skin disorders, including dermatitis
and cancer of the skin. Always wash
thoroughly after contact.
It is illegal to pollute drains,
water
co
Engine compartment overview
2.0L petrol engine
1. Brake/clutch fluid reservoir caps (beneath
covers):
A. Left-hand drive vehicles.
B. Right-hand drive vehicles.
2. Engine oil filler cap.
5. O
SEE MORE:
Control Diagram
NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O =
LIN (local interconnect network) bus
Battery
BJB (battery junction box)
Front height sensor
Rear height sensor
Headlamp leveling control module
Front right fog lamp
Front left fog lamp
Left side rep
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifica
© 2011-2025 Copyright www.rrevoque.org
