Range Rover Evoque: Rolling code device equipment programming
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage door opener receiver (motor
head unit) in the garage, locate the learn or
smart button/switch.
- The name of the button or switch may
vary between manufacturers.
2. Press and release the learn or smart
button.
3. In your vehicle, firmly press the previously
programmed HomeLink opener button
twice and release.
4. Press and hold briefly to complete the
programming process.
HomeLink should now activate the rolling code
device.
READ NEXT:
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator l
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep th
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
SEE MORE:
Any traffic event (broadcast on TMC) in your
area, will be displayed as a warning icon on the
map and an alert may be displayed as a
message giving the road number(s) and
between which junctions the hold-up or event
occurs.
This data is stored in the system for up to of 30
minutes.
The colou
Terrain Response Control Module (ATCM)
CAUTION: Diagnosis
by substitution from a donor vehicle is NOT acceptable. Substitution of control
modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOTES:
If the
© 2011-2025 Copyright www.rrevoque.org
