Range Rover Evoque manuals

Range Rover Evoque: Smart key check

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Entering the vehicle / Smart key check

If the ignition is on or the engine is running and there is no Smart Key inside the vehicle when the last door is closed, the message Smart Key Not Found Refer to Handbook will be displayed in the message centre.

vehicle before it is driven to another Ensure that the Smart Key is in the vehicle before it is driven to another location. Without the Smart Key, if the ignition is turned off, it cannot be turned on again.

If only the ignition is on and the Smart Key is removed from the vehicle and the driver’s door is the last to be closed, the ignition will switch off.

Note: The engine cannot be started without the Smart Key in the vehicle.

READ NEXT:

 Disarming if the smart key and keyless entry fail to work

The vehicle can still be unlocked and the alarm disabled. To unlock the vehicle: 1. Unlock the left side front door using the key blade. The alarm will be triggered. 2. Position the Smart Key agai

 Deactivating the alarm when triggered

If the alarm has been triggered, it can be deactivated by any one of the following methods: - Pressing the unlock button on the Smart Key. - Opening a door using keyless entry. - Positioning a v

 Smart key system transmitters

Any person fitted with an implanted medical device should ensure that the device is kept at a distance of at least 22 cm (8.7 inches) away from any transmitter mounted in the vehicle. This is

SEE MORE:

 Tyre repair kit

If you are in any doubt regarding your ability to carry out the instructions, contact your Dealer/Approved Repairer before attempting the repair. Your vehicle may not be equipped with a spare tyre. If this is the case, your vehicle will be fitted with a Land Rover tyre repair kit which can

 Quarter Panel

Removal NOTES: Within this procedure there are 2 different options depending on type of vehicle body and combination of replacement panels. The quarter panel is manufactured from mild steel. The rocker panel butt joint in option 2 must be MIG brazed due to the location of boron reinforcements.

© 2011-2025 Copyright www.rrevoque.org