Range Rover Evoque: Suspending and resuming cruise control
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Cruise control / Suspending and resuming cruise control
Suspend cruise control with a single press of control (3).
To resume cruise control at the previous set speed, press control (2).
RES (2) should be used only
if the
driver is aware of the set speed and
intends to return to it.
It is not recommended to resume set
speed when a low gear is selected as
excessive engine speeds will occur.
READ NEXT:
Automatic switch off
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park
Cruise eco data
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH
SEE MORE:
Health and Safety Precautions
Introduction
Modern vehicles contain many materials and liquids which if not handled with
care can be hazardous to both personal
health and the environment. Also, many of the procedures associated with vehicle
maintenance and repair involve physical
hazards or other risks to health.
This subsecti
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd or reverse gears.
Automatic transmission: HDC can be used in
D, R and CommandShift 1, 2 or 3.
Note
© 2011-2025 Copyright www.rrevoque.org
