Range Rover Evoque: Timing Chain

Removal

NOTES:

Some illustrations may show the engine removed for clarity.

Some variation in the illustrations may occur, but the essential information is always correct.

1. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

3. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

4.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

5.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

6.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

8. CAUTIONS:

Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning.

Note the fitted position of the component prior to removal. Do not disassemble further if removed for access only

Range Rover Evoque. Engine - GTDi 2.0L Petrol

9.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. CAUTION: Install a new friction washer.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

2. CAUTIONS:

Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning.

Make sure that these components are installed to the noted removal position.

Only tighten the bolts finger-tight at this stage.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

3.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

4. Torque: 10 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

5. Torque: 10 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

6. CAUTION: Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning. Torque: 72 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

8. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

READ NEXT:

 Timing Cover

Special Tool(s) 303-021 Engine support bracket JLR-303-1591 Lifting Bracket, Engine - Rear Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustratio

 Valve Cover

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Engine - Removal and Installation

Removal Special Tool(s) 205-857 Remover, Halfshaft 1. Refer to: Battery Tray (414-01 Battery, Mounting and Cables, Removal and Installation). 2. Refer to: Air Conditioning (A/C) System Recovery, Evacu

SEE MORE:

 Introduction to rear seat entertainment (RSE)

The RSE system consists of two screens. Separate programmes can be viewed or heard by rear seat occupants. Supervisory control is made from the front seats. Audio and video programmes for each or both sides of the RSE, can be selected from the Supervisor screen. The remote control can be locke

 Hydraulic Brake Actuation

Hydraulic Brake Actuation LHD AWD/RHD AWD - Component Location NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive) installation similar. COMPONENT LOCATION Brake pedal Hydraulic pipes Integrated HCU (hydraulic control unit) and ABS (anti-lock brake system) module Brake ma

© 2011-2025 Copyright www.rrevoque.org