Range Rover Evoque: Topping up the coolant
Never remove the filler cap
when the
engine is hot - escaping steam or
scalding water could cause serious
personal injury.
Antifreeze is highly inflammable. Do
not allow antifreeze to come into
contact with naked flames or other
sources of ignition (e.g. a hot engine)
- a fire may result.
Unscrew the filler cap slowly,
allowing the pressure to escape
before removing completely.
When travelling in
territories where the
water supply contains salt, always
ensure you carry a supply of fresh (rain
or distilled) water. Topping up with salt
water will cause serious engine
damage.
Top-up to the MAX indicator mark on the side of the expansion tank. Use only a 50% mix of water and Texaco XLC antifreeze.
Note: In an emergency - and only if the approved antifreeze is unavailable - top-up the cooling system with clean water, but be aware of the resultant reduction in frost protection.
Do not top-up or refill with conventional antifreeze formulations. If in doubt consult a qualified technician.
Ensure the cap is tightened fully after top-up is completed by turning the cap until the ratchet cap clicks.
READ NEXT:
Coolant antifreeze
Antifreeze is poisonous and
can be
fatal if swallowed - keep containers
sealed and out of the reach of
children. If accidental consumption is
suspected, seek medical attention
immediately.
If
Brake/clutch fluid check
Seek qualified assistance
immediately if brake pedal travel is
unusually long or if there is any
significant loss of brake fluid. Driving
under such conditions could result in
extended stopping
Topping up the brake/clutch fluid
Brake fluid will damage
painted
surfaces. Soak up any spillage with an
absorbent cloth immediately and wash
the area with a mixture of car shampoo
and water.
Only use new fluid from an airtigh
SEE MORE:
Rain sensor
Ensure that the wipers are
switched off
before entering a car wash. If the rain
sensitive wipers operate during the car
washing process, damage may occur to
the wiper mechanism.
The rain sensor is able to detect the presence
and amount of rain/dirt/snow on the
windscreen and automatically
Headlamp Adjustment
NOTE: The headlamp setting is 1.2 % below horizontal and parallel.
1. Align the headlamp beam setting equipment to one headlamp.
2. Switch the headlamps on and to dipped beam.
3. NOTE: NAS vehicles have vertical adjustment only.
Adjust the headlamps with an Allen Key.
Rotate the adjuster 'A' for
