Range Rover Evoque: Commandshift™
To return to Sport mode after CommandShift
has been selected, move the selector back to D
then back to Sport mode. Transmission
Commandshift Selected will appear in the
message centre when the transmission is in
CommandShift mode.
Note: In order to protect the engine, the
transmission will automatically change up to
prevent over-revving, or down if the engine is
labouring.
READ NEXT:
Push the accelerator pedal fully down to
achieve rapid acceleration in automatic mode.
When the pedal is relaxed, normal gear
changing will resume.
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is sw
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
SEE MORE:
Special Tool(s)
310-198
Installer, Teflon Seal
310-199
Re-shape Tool, Teflon Seal
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Disconnect the battery ground c
To prevent accidental
operation,
never leave the Smart Key in the
vehicle if children or animals are also
left in the vehicle.
Note: The operational range of the Smart Key
will vary considerably depending on
atmospheric conditions and interference from
other transmitting devices.
Note:
© 2011-2025 Copyright www.rrevoque.org
