Range Rover Evoque: Floor Console Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on both sides.
NOTE: LH illustration shown, RH is similar.
Torque: 1.9 Nm
Vehicles with manual transmission
2. Refer to: Gearshift Lever Knob (308-06 Manual Transmission/Transaxle External Controls, Removal and Installation).
3. CAUTION: Carefully release the retaining clips.
4.
5. CAUTION: Carefully release the retaining clips.
Vehicles with automatic transmission
6. CAUTION: Carefully release the retaining clips.
7.
All vehicles
8. NOTE: Do not disassemble further if the component is removed for access only.
Torque:
M5 bolt 1.5 Nm
Screw 1.1 Nm
9. Torque: 1.1 Nm
10. Torque: 1.1 Nm
11. Torque: 1.1 Nm
12. Torque: 1.1 Nm
Installation
1. To install, reverse the removal procedure.
2. Connect Land Rover approved diagnostic equipment to vehicle. Read and clear the stored DTCs.
Torque Specifications
READ NEXT:
Locks, Latches and Entry Systems
Principle of Operation
For a detailed description of the locks, latches and entry systems and
operation, refer to the relevant Description and
Operation section of the workshop manual REFER to: Handl
SEE MORE:
Deselecting valet mode
If Valet mode is active when you enter the
vehicle, touch the Valet button to view the
Valet mode screen.
Enter your four digit PIN and touch the OK
button.
Valet mode is deactivated is displayed.
- The tailgate will return to the previously set
security requirement.
- All touch screen funct
Fender Apron Panel Reinforcement
Removal
NOTE: The fender apron panel reinforcement is manufactured from mild
steel.
1.
2. For additional information relating to this repair procedure please see
the
following:
For additional information, refer to: Health and Safety Precautions (100-00
General Information, Description and Operat
