Range Rover Evoque: Oil Pump

Removal

NOTES:

Some illustrations may show the engine removed for clarity.

Removal steps in this procedure may contain installation details.

1. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

3. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

4. Refer to: Air Cleaner (303-12B Intake Air Distribution and Filtering - GTDi 2.0L Petrol, Removal and Installation).

5. Refer to: Air Conditioning (A/C) Compressor - GTDi 2.0L Petrol (412-01 Climate Control, Removal and Installation).

6. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L Petrol, General Procedures).

7. CAUTION: Using a suitable tool, hold the oil pump gear when removing the centre bolt.

• Torque: 25 Nm

8.

9. Torque: 8 Nm

10. Torque: 25 Nm

11. Torque: 35 Nm

12. Torque: 4 Nm

13.

14. Torque: 10 Nm

15. NOTE: During installation tighten the bolts simultaneously or crosswise.

Torque:

• Stage 1: 10 Nm
• Stage 2: 20 Nm

Installation

1. NOTE: Make sure that all traces of the old sealant are removed from the mating faces. To install, reverse the removal procedure.

2. NOTES: Install a new gasket.

Note - Apply sealant WSE-M4G323-A6 in a 2-3mm diameter on the engine oil sump as shown. The component must be installed and tightened within 10 minutes of sealant application.

3. NOTE: Note - TAS | Engine | Apply sealant WSE-M4G323-A6 in a 2-3mm diameter on the engine front cover as shown. The component must be installed and tightened within 10 minutes of sealant application.

READ NEXT: