Range Rover Evoque: Rear Door Trim Panel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Torque: 1.3 Nm

Range Rover Evoque. Interior Trim and Ornamentation

2. Torque: 6 Nm

Range Rover Evoque. Interior Trim and Ornamentation

3. Torque: 6 Nm

Range Rover Evoque. Interior Trim and Ornamentation

4.

Range Rover Evoque. Interior Trim and Ornamentation

5.

Range Rover Evoque. Interior Trim and Ornamentation

6.

Range Rover Evoque. Interior Trim and Ornamentation

7. NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Interior Trim and Ornamentation

8. Torque: 0.6 Nm

Range Rover Evoque. Interior Trim and Ornamentation

9.

Range Rover Evoque. Interior Trim and Ornamentation

10. Torque: 1 Nm

Range Rover Evoque. Interior Trim and Ornamentation

11.

Range Rover Evoque. Interior Trim and Ornamentation

Installation

1. To install, reverse the removal procedure.

Liftgate Trim Panel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. NOTE: Make sure the two metal clips are removed from the liftgate.

Range Rover Evoque. Interior Trim and Ornamentation

3. NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Interior Trim and Ornamentation

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Headliner

Removal NOTES: Removal steps in this procedure may contain installation details. Vehicles with glass roof panel shown, vehicles without glass roof panel similar. All vehicles 1. Refer to: Windshield

 Engine Cover GTDi 2.0L Petrol, Engine Cover TD4 2.2L Diesel

Engine Cover GTDi 2.0L Petrol Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. NOTE: Do not disassemble further if the component is removed for access only. Inst

 Loadspace Trim Panel

CAUTION: LH illustration shown, RH is similar. NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. 2. 3. 4. Torque: 1.4 Nm 5. Torque: 20 Nm 6. NOTE: LH side o

SEE MORE:

 Headlamps

Moving the nearside headlamp unit to access bulbs; 1. Remove the two plastic fixings. 2. Pull the tube up to release from the air box. This will allow more room for manoeuvrability. 3. Remove the four grille fixings. 4. Remove the two retaining bolts. 5. At the rear of the headlamp unit, p

 Glass Roof Panel Blind

Removal CAUTION: When removing and installing the glass roof panel blind, extreme cleanliness must be observed at all times. NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. NOTE: The procedure must be carried out on both sides. Refer to: A-Pillar Trim Panel

© 2011-2025 Copyright www.rrevoque.org