Range Rover Evoque: Rear seat access (coupe models)
The front seats tilt and power slide forwards for
entry to and exit from the rear seats. Operation
is controlled by a lever and switch.

1. Lift the locking lever and pivot the seatback
forwards.
2. Press the front of the switch to power the
seat forwards.
3. To return the seat, pivot the seatback until
it locks into its previous position, then
press and hold the rear of the switch to
power the seat rearwards until it locks into
position.
READ NEXT:
Folding and raising the rear seats
The split fold rear seat of 5 door models can be
folded completely, or partially at 60/40 split, to
accommodate loads and still retain seating for
passengers.
Adjust the head restraint so
that the
top of the head restraint is above the
centre line of the head. An incorrectly
adjusted head restraint increases the
risk of death or serious injury in the
SEE MORE:
Ensure that the areas around
air intakes
and the front grille are clean and clear of
debris. Pay particular attention to the
lower grille and radiator. Failure to do
so may cause the engine to overheat,
leading to severe engine damage.
Ensure that the vehicle underside is cleaned as
soon
Removal
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
General Equipment
Transmission jack
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Disconnect the battery
© 2011-2025 Copyright www.rrevoque.org
