Range Rover Evoque: C-Pillar Upper Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.

2.

3.

4.

5. Torque: 6 Nm

6.

Installation
1. To install, reverse the removal procedure.
C-Pillar Lower Trim Panel
Removal
1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and
Installation).
2. Refer to: Loadspace Trim Panel (501-05 Interior Trim and
Ornamentation, Removal and Installation).
3.

4.

5.

Installation
1. To install, reverse the removal procedure.
READ NEXT:
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and
Installation).
2. Refer to: Loadspace Trim Panel (501-05 Int
Torque Specifications
Rear Quarter Panel Moulding
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Discard the retaining clips.
Make sure that the centre
Rear View Mirrors - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
DDM (driver door module)
Driver exterior mirror
Exterior mirro
SEE MORE:
DESCRIPTION
Engine Control Module (ECM)
The ECM is located at the rear of the engine compartment, between the
bulkhead and the engine sound insulation. The ECM is located in a plastic molded
carrier which in turn is located in a bracket attached to the vehicle structure.
The ECM is connected to t
Capacities
Fuel System Pressure Release GTDi
2.0L Petrol
Draining
1. Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety
Precautions (100-00 General Information, Description and
Operation).
2. Remove the fuel pump fuse.
3. Remove the fuel filler cap.
4. Start the engine and allow it
© 2011-2025 Copyright www.rrevoque.org
