Range Rover Evoque: Driver Seat Cushion Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. Refer to: Front Seat Cushion Cover - Vehicles With: Sports Seats (501-10 Seating, Removal and Installation).
Vehicles with heated front seats
4. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
5.
Installation
1. To install, reverse the removal procedure.
Driver Seat Cushion Heater Mat Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. Refer to: Front Seat Cushion Cover - Vehicles With: Sports Seats (501-10 Seating, Removal and Installation).
4. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
5.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Passenger Seat Cushion Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Spe
Glass, Frames and Mechanisms - Component Location, System
Operation and Component Description
Component Location
COMPONENT LOCATION - DOOR MECHANISMS
Passenger door glass motor
Passenger door module
Rear door glass motor
Rear door module
Rear fuse box
Rear door glass motor
Rear door m
SEE MORE:
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6 inches) away from
the HomeLink transceiver in the rear-view
mirror, keeping the indicator lamp in
Transfer Case Rear
Seal
Special Tool(s)
100-012
Slide Hammer
205-871
Installer, Transfer Case Rear Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
