Range Rover Evoque: Motorway
After selecting Motorway from the menu, enter the road name or number, then select an entrance or exit. All of the entrance or exit junctions for the chosen road are displayed.
The map showing the selected motorway and the selected exit junction is displayed.
The destination has now been set and the route is calculated.
READ NEXT:
Points of interest (POI)
After selecting Points of interest from the
menu, touch Name to input the POI name, for
example, Petrol to display fuel stations on the
map, or touch List for a list of POIs.
Alternatively, choose
Dealer locations
Details of Land Rover Dealers are held on the
Navigation System hard drive as a points of
interest (POI) category. Certain Dealers may be
located in areas that are not fully mapped on
the hard dri
Entry by town
If a town name is entered first, the points of
interest listed will be restricted to that town.
- From the Input POI Name screen, touch
Town.
- Enter the town name required.
- Touch List to displ
SEE MORE:
Exterior Trim and Ornamentation
Torque Specifications
Rear Quarter Panel Moulding
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Discard the retaining clips.
Make sure that the centre part of the clip is fully
removed from the outer part of the clip. It is not
possible to prevent
Dynamic stability control (amber)
Dynamic stability control (amber)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp flashes while driving, the
DSC system is active. If the lamp illuminates
continuously while driving, there is a fault with
the DSC system. The vehi
© 2011-2025 Copyright www.rrevoque.org
