Range Rover Evoque manuals

Range Rover Evoque: Oil Cooler

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol / Oil Cooler

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).

4. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L Petrol, General Procedures).

5. Refer to: Engine Cover - GTDi 2 0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

6.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7. CAUTION: Make sure that the area around the component is clean and free of foreign material.

READ NEXT:

 Oil Pan

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Oil Pump

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Timing Chain

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. 1. Refer to: Specifications

SEE MORE:

 Spare Wheel Well

Removal NOTES: The spare wheel well is manufactured from mild steel, it includes the spare wheel retaining bracket. The panel is serviced less its weld studs 1. The spare wheel well is replaced in conjunction with: Rear bumper cover Rear bumper Back panel Rear bumper mounting LH & RH Rea

 Fuel Fired Booster Heater Control Module (FFBHCM)

Fuel Fired Booster Heater Module (AHCM)  CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.  NOT

© 2011-2025 Copyright www.rrevoque.org