Range Rover Evoque: Powered tailgate opening height
The maximum opening height can be set as required. This is useful in parking areas with low ceiling heights or just for ease of use.
1. Open the tailgate to the position which you want to set as the maximum height. Press any tailgate control to stop movement at the required position. Final position can be achieved manually if required.
2. Ensure that the tailgate is stationary for at least three seconds.
3. Press and hold the tailgate close switch for ten seconds to set the maximum opening height.
4. Close the tailgate, then open again to check that it opens to the programmed height.
Note: If, after performing part 3 of the process the tailgate closes automatically, the required height has not been set. Repeat the process ensuring that all steps are adhered to.
To reset the maximum opening height, repeat the process, but when the tailgate reaches its current programmed height, manually move it to the fully open position before pressing and holding the button.
READ NEXT:
Programmed position loss
The powered tailgate may lose its position
memory if there are multiple object detections
or if battery voltage is low. Powered operation
may be inhibited. To reset the tailgate;
1. Manually close
Changing the smart key batttery
When the battery needs renewing, there will be
a significant decrease in the effective range and
the message SMART KEY BATTERY LOW will
be displayed in the message centre.
To renew the battery:
SEE MORE:
Engine Wiring Harness GTDi 2.0L Petrol
Removal
CAUTIONS:
Make sure that the wiring harness is not twisted or damaged on removal. Failure
to follow this instruction may result
in damage to the vehicle.
Take extra care not to damage the wiring harness clips.
NOTE: Removal steps in this procedure may contain installation details.
1. Disc
Quarter Panel
Removal
NOTES:
Within this procedure there are 2 different options depending on type of
vehicle body and combination of replacement panels.
The quarter panel is manufactured from mild steel.
The rocker panel butt joint in option 2 must be MIG brazed due to the location
of boron reinforcements.
