Range Rover Evoque: Rear Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm

2. Torque: 6 Nm

3. Torque: 6 Nm

4.

5.

6.

7. NOTE: Do not disassemble further if the
component is removed for access only.

8. Torque: 0.6 Nm

9.

10. Torque: 1 Nm

11.

Installation
1. To install, reverse the removal procedure.
Liftgate Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. NOTE: Make sure the two metal clips are removed
from the liftgate.

3. NOTE: Do not disassemble further if the
component is removed for access only.

Installation
1. To install, reverse the removal procedure.
READ NEXT:
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Vehicles with glass roof panel shown, vehicles without glass roof panel similar.
All vehicles
1. Refer to: Windshield
Engine Cover GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Do not disassemble further if the
component is removed for access only.
Inst
CAUTION: LH illustration shown, RH is similar.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.
2.
3.
4. Torque: 1.4 Nm
5. Torque: 20 Nm
6. NOTE: LH side o
SEE MORE:
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1.
2.
3. Torque: 25 Nm
4. Torque: 25 Nm
5.
6. Torque: 6 Nm
7. NOTE: If equipped.
Torque: 10 Nm
8.
9. Torque: 6 N
Parking Aid Module
The parking aid module is located on the LH side of the luggage compartment,
behind the 'C' pillar trim panel.
The parking aid module has three connectors which provide for power, ground and
CAN bus connections, front parking aid
sensors and rear parking aid sensors.
The high
© 2011-2025 Copyright www.rrevoque.org
