Range Rover Evoque: Rear wiper
If reverse gear is selected while the front wipers are operating, the rear wiper will start automatically and continue as long as reverse gear is selected. The wipe interval is dependent on the front wipers setting.
If reverse gear is selected while the rear wiper control is in the INT position, the wiper will operate for a single sweep of the rear screen.
When stationary, if the tailgate is opened while the rear wiper is operating, the wiper will stop.
When the tailgate is closed, the wiper will start to operate again after a delay of three seconds.
If the tailgate is open and vehicle speed is above 3km/h (2mph) the wiper will operate normally.
READ NEXT:
Wiper blade replacement
This subject is covered in the Maintenance
section. See 175, WIPER BLADE
REPLACEMENT.
Electric windows and panoramic roof blind
Electric windows and panoramic roof blind
1. Briefly pull a switch fully up and release,
the window will continue to rise until fully
closed. Briefly press a switch fully down
and release, the w
SEE MORE:
Transmission Control Module (TCM), Gear Shift Module (GSM)
TRANSMISSION CONTROL MODULE (TCM)
TCM
Neutral 'N' position
Park 'P' position
Position sensor/manual shaft
Electrical connector
The TCM is located on the top of the transmission casing and is connected on
the high speed CAN (controller area network)
bus to send and receive information to and
Using cruise control
Using cruise control
1. Set target speed, or increase speed.
2. RES. Resume set speed.
3. CAN. Suspends cruise control operation
without erasing memorised speed.
4. Decrease set speed.
Note: Cruise control is not available when
using Hill Descent Control or when a Terrain
Response special
© 2011-2025 Copyright www.rrevoque.org
