Range Rover Evoque: Reprogramming a single garage door opener button
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator lamp begins to
flash.
2. Without releasing the button, position the
hand-held transmitter approximately 50 to
150 mm (2 to 6 inches) away from the
HomeLink transceiver, keeping the
indicator lamp in view.
3. Carry out Step 3 of Programming.
READ NEXT:
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep th
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or
SEE MORE:
Installation
Special Tool(s)
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. NOTE: This step is only required if previously
removed.
2. NOTE: This step is only
Dynamic stability control (amber)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp flashes while driving, the
DSC system is active. If the lamp illuminates
continuously while driving, there is a fault with
the DSC system. The vehi
© 2011-2025 Copyright www.rrevoque.org
