Range Rover Evoque: Starting a disabled vehicle using a starting aid
To start the vehicle using a starting aid or a
slave battery, follow the instructions in the
sequence given.
1. Connect the positive (Red) booster cable to
the positive (+) battery terminal of the
discharged battery.
2. Connect the negative (Black) booster cable
to the vehicle earth point.
3. Start the engine and allow it to idle.
4. Disconnect the negative (Black) booster
cable from the battery terminal of the
vehicle.
5. Disconnect the positive (Red) booster
cable from the battery terminal of the
vehicle.
READ NEXT:
Special tools are required to refit the battery
after removal, therefore battery removal and
refit should be carried out only by qualified
personnel. Consult your Dealer/Authorised
Repairer.
If the vehicle battery should require charging,
the battery must be removed from the vehicle.
Consult your Dealer/Authorised Repairer.
Battery disconnection,
removal and
replacement should be c
Disconnecting the battery can affect a number
of vehicle systems, especially if there is
insufficient battery power prior to
disconnection. For example, the alarm may
trigger depending on it's sta
SEE MORE:
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. WARNING: Make sure that
Principle of Operation
For information on the description and operation of the system, refer to
relevant section of the workshop manual. REFER
to: (417-01 Exterior Lighting)
Note that the stoplamps will be activated automatically under certain
conditions when the ride and handling optimization
fun
© 2011-2025 Copyright www.rrevoque.org
