Range Rover Evoque manuals

Range Rover Evoque: Terrain response operation

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Terrain response / Terrain response operation

Terrain Response selection is via one of two centre console switches. Depending on vehicle specification, the control switches may include a Dynamic program setting. Use the switches to move through up to five program selections.

The currently selected program icon will be displayed in the message centre.

Note: Changing between special programs will alter various vehicle settings, e.g., engine revs while at the current accelerator pedal position may alter, or the steering feel might change.

These changes are not dramatic but will be noticable.

It is advisable to experiment with the available settings in an environment that will not affect other road users.

Dynamic

READ NEXT:

 Dynamic

This special program is associated with a driving style rather than a type of terrain. Choose this program for exploiting the vehicle's full on-road potential, providing a more focussed and invo

 General program (special programs off)

This program is compatible with all on and off-road conditions. If not already active, it should be selected before driving on surfaces which are similar to a hard road surface. Dry cobbles, tar

 Grass-gravel-snow

This program should be used where a firm surface is covered with loose or slippery material. Note: For deep snow it is recommended that the Sand program is selected. Note: If the vehicle is una

SEE MORE:

 Hill descent control (HDC) controls

Hill descent control (HDC) controls 1. Press to switch HDC on and off. 2. Press to increase the set speed. 3. Press to decrease the set speed. Manual transmission: HDC can be used in 1st, 2nd or reverse gears. Automatic transmission: HDC can be used in D, R and CommandShift 1, 2 or 3. Note

 To erase all programming

For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off). 2. Press and hold the two outer HomeLink buttons. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 second

© 2011-2025 Copyright www.rrevoque.org