Range Rover Evoque: Airbag system
The components that make up
the
airbag system are sensitive to
electrical or physical interference,
either of which could easily damage
the system and cause inadvertent
operation or a malfunction of the
airbag module.
To prevent malfunction of the airbag system always consult your Dealer/Authorised Repairer before fitting any of the following: - Electronic equipment such as a mobile phone, two-way radio or in-car entertainment system.
- Accessories attached to the front of the vehicle.
- Any modification to the front of the vehicle.
- Any modification involving the removal or repair of any wiring or component in the vicinity of any of the airbag system components, including the steering wheel, steering column, instrument or fascia panels.
- Any modification to the fascia panels or steering wheel.
READ NEXT:
Disability modifications
Occupants with disabilities which may require
modification of the vehicle, must contact a
Dealer/Authorised Repairer before any
modifications are made.
Parts and accessories
The fitting of non-approved
parts and
accessories, or the carrying out of
non-approved alterations or
conversions, may be dangerous and
could affect the safety of the vehicle
and occupants and
Road testing dynamometers (rolling roads)
It is essential that any dynamometer testing is
carried out only by a qualified person, familiar
with the dynamometer testing and safety
procedures practised by Dealers/
Authorised Repairers.
SEE MORE:
Loadspace Trim Panel
CAUTION: LH illustration shown, RH is similar.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.
2.
3.
4. Torque: 1.4 Nm
5. Torque: 20 Nm
6. NOTE: LH side only.
7.
5-door
8.
9. CAUTION: Take extra care not to damage the
clips.
Release the lower retainin
Desiccant Bag GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Condenser - GTDi 2.0L Petrol (412-01 Climate Control,
Removal and Installation).
3. Torque: 11 Nm
Installation
1
