Range Rover Evoque: Parts and accessories

parts and The fitting of non-approved parts and accessories, or the carrying out of non-approved alterations or conversions, may be dangerous and could affect the safety of the vehicle and occupants and also invalidate the terms and conditions of the vehicle warranty.
Land Rover will not accept any liability for death, personal injury or damage to property which may occur as a direct result of fitment of non-approved accessories or the carrying out of non-approved conversions to Land Rover vehicles.

READ NEXT:

 Road testing dynamometers (rolling roads)

It is essential that any dynamometer testing is carried out only by a qualified person, familiar with the dynamometer testing and safety procedures practised by Dealers/ Authorised Repairers.

 Safety in the garage

If the vehicle has been driven recently, do not touch exhaust and cooling system components until the engine has cooled. Never leave the engine running in an unventilated area - exhaust gases

 Fuel system

Under no circumstances should any part of the fuel system be dismantled or replaced by anyone other than a suitably qualified vehicle technician. Ensure sparks and naked lights are kept away f

SEE MORE:

 Suspension Top Mount

Removal NOTES: The suspension top mount is manufactured from mild steel and RP220. The service panel is serviced not fully spot welded. The panel is serviced less its weld studs 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2.

 Stoplamps

Principle of Operation For information on the description and operation of the system, refer to relevant section of the workshop manual. REFER to: (417-01 Exterior Lighting) Note that the stoplamps will be activated automatically under certain conditions when the ride and handling optimization fun

© 2011-2024 Copyright www.rrevoque.org