Range Rover Evoque: Anti-trap protection

blind onto Closing a window or roof blind onto any part of the body can result in serious injury.
Before closing a window or the roof blind, ensure that no occupants have any part of their body in a position where it could be trapped. Even with an anti-trap system death or serious injury could occur.

Anti-trap protection will stop window or roof blind movement if an obstruction or resistance is detected. Check the window or roof blind and its aperture and remove any obstructions (e.g.

ice, etc.).

If it is still necessary to raise the window, the override procedure is as follows: 1. Attempt to close the window, anti-trap will prevent closure and lower the window slightly.

2. Within ten seconds attempt to raise the window again, anti-trap will prevent closure and lower the window slightly.

3. Attempt to close the window for a third time, this time hold the switch in the close position. Hold until closed.

Note: If this procedure fails to remove the blockage, the window operation may need to be reset.

READ NEXT:

 Resonance with lowered windows

if a resonance or booming sound occurs when a rear window is open, lowering an adjacent front window by approximately 25mm (1 inch) will eliminate the condition.

 Mirrors

 Exterior mirrors

Exterior mirrors 1. Mirror selector switches. Press to select the left or right mirror. 2. Mirror adjustment switch. Move up/down/left or right to adjust the mirror glass. 3. Press both select

SEE MORE:

 Topping up the washer fluid

The washer reservoir supplies the front and rear screen washer jets and headlamp washer jets. Check and top-up the reservoir level at least every week. Always top-up with screen washer fluid to prevent freezing. Operate the washer switches periodically to check that the nozzles are clear and

 Front Bumper Mounting

Removal NOTE: The front bumper mounting is manufactured from HSLA300 and mild steel. 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The front bumper mounting is replaced in conjunction with: Front bumper cover Front bumper

© 2011-2024 Copyright www.rrevoque.org