Range Rover Evoque: Automatic systems
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Hill descent control / Automatic systems
Gradient Acceleration Control (GAC) and Hill Start Assist are not active while HDC is operating.
GAC will limit vehicle acceleration on steep descents, allowing the driver to feel more in control of the vehicle.
Hill Start Assist activates when starting a hill ascent from a stationary position. When the foot brake is released Hill Start Assist smoothly releases the brake pressure, allowing the vehicle to move away without rolling backwards.
Any fault with GAC or Hill Start Assist will be indicated by the DSC warning lamp being illuminated and a message in the message centre.
READ NEXT:
Parking aids
Parking aids
1. Parking aid on/off switch. The switch
indicator will illuminate.
When reverse gear is selected, the front
and rear parking sensors are activated
automatically.
To turn off, pre
Towing
The rear sensors are automatically disabled
when a trailer with an approved electrical
connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking aids sensors.
SEE MORE:
Front Suspension - Component Location, System Operation and Component Description
Component Location
RH (right-hand) spring and damper assembly
Stabilizer bar link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub and bearing assembly
Lower control arm
Subframe
Overview
The front suspension features long travel McPherson struts to optimize on a
Front Wheel Bearing
Special Tool(s)
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
204-727A
Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-807
Installer, Front Wheel Bearing
JLR-204-808
Installer, Front Wheel Bearing
General Equipment
Copper Hammer
Hydraulic press
© 2011-2026 Copyright www.rrevoque.org - 0.0036
