Range Rover Evoque: Parking aids
READ NEXT:
Parking aids
Parking aids
1. Parking aid on/off switch. The switch
indicator will illuminate.
When reverse gear is selected, the front
and rear parking sensors are activated
automatically.
To turn off, pre
Towing
The rear sensors are automatically disabled
when a trailer with an approved electrical
connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking aids sensors.
Cleaning the sensors
When washing the vehicle do
not aim
high pressure water jets directly at the
sensors. Do not use abrasive materials
or hard/sharp objects to clean the
sensors. Only use approved vehicle
shampo
SEE MORE:
Loadspace Trim Panel
CAUTION: LH illustration shown, RH is similar.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.
2.
3.
4. Torque: 1.4 Nm
5. Torque: 20 Nm
6. NOTE: LH side only.
7.
5-door
8.
9. CAUTION: Take extra care not to damage the
clips.
Release the lower retainin
Engine Timing
Special Tool(s)
303-1565
Locking Tool, Camshaft
308-511
Installer, Transmission Output Shaft Seal
JLR-303-1594
Locking Tool, Driveplate
JLR-303-748
Locking Tool, Crankshaft
Activation
1.
2. Install the special tool.
Special Tool(s): JLR-303-748
3. Rotate the engine clockwise until the crankshaft
© 2011-2024 Copyright www.rrevoque.org
