Range Rover Evoque manuals

Range Rover Evoque: Cleaning the sensors

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Parking aids / Cleaning the sensors

not aim When washing the vehicle do not aim high pressure water jets directly at the sensors. Do not use abrasive materials or hard/sharp objects to clean the sensors. Only use approved vehicle shampoo.

The sensors should be kept clean to maintain accuracy and performance.

READ NEXT:

 System fault

If a system fault is detected, a long high-pitched tone will sound and the switch indicator will flash. A message will be displayed in the message centre. Contact your Dealer/ Authorised Repairer

 Rear view camera

It remains the driver's responsibility to detect obstacles and estimate the vehicle's distance from them when reversing. When Reverse (R) is selected the camera provides a wide-angle rear view

 Park assist

SEE MORE:

 Front Stabilizer Bar Bushing

Removal NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the front wheels

 Transmission Control Module (TCM), Gear Shift Module (GSM)

TRANSMISSION CONTROL MODULE (TCM) TCM Neutral 'N' position Park 'P' position Position sensor/manual shaft Electrical connector The TCM is located on the top of the transmission casing and is connected on the high speed CAN (controller area network) bus to send and receive information to and

© 2011-2026 Copyright www.rrevoque.org