Range Rover Evoque: Stability control
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Stability control
- Dynamic stability control (DSC)
- Dsc warning lamp
- Disabling dsc
- Re-enabling dsc
- Electronic traction control (ETC)
- Adaptive dynamics
READ NEXT:
Dynamic stability control (DSC)
DSC is automatically enabled each time the
engine is started, and is automatically enabled
by some of the Terrain response special
programs.
The vehicle is not designed
for
cornering at the sa
Dsc warning lamp
The amber DSC warning lamp in
the instrument panel illuminates
briefly when the ignition is
switched on and extinguishes when the engine
is started.
If the lamp flashes while driving, the DSC
Disabling dsc
Safety may be reduced by
inappropriately disabling DSC. In the
majority of driving situations, and
particularly on-road, it is
recommended that you do not disable
DSC.
In some driving condition
SEE MORE:
Steering Linkage
Tie Rod End
Special Tool(s)
205-754A
Splitter, Ball Joints
Removal
NOTE: RH illustration shown, LH is similar.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and
Installation).
3.
4. CAUTIO
Tyre repair kit
If you are in any doubt
regarding your
ability to carry out the instructions,
contact your Dealer/Approved
Repairer before attempting the repair.
Your vehicle may not be equipped with a spare
tyre. If this is the case, your vehicle will be
fitted with a Land Rover tyre repair kit which
can
© 2011-2025 Copyright www.rrevoque.org
