Range Rover Evoque: Lower Arm
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
NOTES:
RH illustration shown, LH is similar.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. WARNING: Make sure that a new nut is installed. Torque: 60 Nm
4.
5. WARNING: Make sure that a new bolt is installed. Torque: 200 Nm
6. WARNING: Make sure that a new bolt is installed.
Torque:
Stage 1: 48 Nm
Stage 2: 180
READ NEXT:
Front Stabilizer Bar AWD
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
Only use clean water as a lubricant for the bushing, if required.
Removal steps in this pro
Front Stabilizer Bar Bushing
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure
Wheel Knuckle
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
sus
SEE MORE:
B-Pillar Reinforcement
Removal
NOTES:
The B-Pillar reinforcement is manufactured from boron steel.
The B-Pillar reinforcement is unpicked from the side panel reinforcement,
'ring-frame', it is not serviced separately.
There are 2 NVH components serviced on the new B-Pillar reinforcement.
1. The B-Pillar reinforcement i
Dab radio controls
Dab radio controls
See 104, TOUCH SCREEN OVERVIEW.
1. DAB Radio: Band selection. Touch to view
and select a DAB band (DAB 1, 2 or 3). The
radio will tune to the last used channel on
that band. Touch again to close.
The DAB band selection box will close
automatically after 5 seconds without
© 2011-2025 Copyright www.rrevoque.org
