Range Rover Evoque: Front Suspension

READ NEXT:

 Front Suspension - Component Location, System Operation and Component Description

Component Location RH (right-hand) spring and damper assembly Stabilizer bar link Stabilizer bar LH (left-hand) spring and damper assembly Wheel knuckle Hub and bearing assembly Lower control

 Front Wheel Bearing

Special Tool(s) 204-305 Remover, Wheel Bearing 204-726 Remover/Installer, Wheel Bearing 204-727A Installer, Wheel Bearing JLR-204-806 Support Tool, Wheel Knuckle JLR-204-807 Installer, Front Wheel B

 Lower Arm

Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTES: RH illustration shown, LH is similar. Removal steps in this procedure may contain installat

SEE MORE:

 Clutch Controls - Vehicles With: M66 6-Speed Manual Transmission AWD

Torque Specifications Clutch Controls - Component Location COMPONENT LOCATION Brake/clutch reservoir Clutch pedal bracket Clutch master cylinder High pressure hose Connector Clutch slave cylinder and release bearing Hydraulic adaptor and peak torque limiter Bleed screw Clutch pedal Line

 Engine Wiring Harness TD4 2.2L Diesel, Vehicles With: M66 6-Speed Manual Transmission AWD/M66 6-Speed Manual Transmission FWD

Removal CAUTIONS: Make sure that the wiring harness is not twisted or damaged on removal. Failure to follow this instruction may result in damage to the vehicle. Take extra care not to damage the wiring harness clips. NOTES: Some variation in the illustrations may occur, but the essential informa

© 2011-2025 Copyright www.rrevoque.org