Range Rover Evoque: Rear Wheel Bearing
Special Tool(s)
204-250
Wheel bearing install and removal tool
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-809
Installer, Rear Wheel Bearing
JLR-204-810
Installer, Rear Wheel Bearing
General Equipment
- Copper Hammer
- Hydraulic press
- Punch
- Vise
Removal
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel Knuckle (204-02 Rear Suspension, Removal and Installation).
3.
- Special Tool(s): JLR-204-806
- Special Tool(s): 204-726
- General Equipment: Hydraulic press
4.
- General Equipment: Vise
- General Equipment: Copper Hammer
- General Equipment: Punch
5.
- Special Tool(s): 204-305
- General Equipment: Hydraulic press
6. Clean all the mating faces and reusable parts thoroughly and check for damage.
7.
8. NOTE: Note the orientation of the component prior to removal.
- Special Tool(s): 204-250
- General Equipment: Hydraulic press
Installation
1. CAUTION: Make sure that the area around the component is clean and free of foreign material.
Special Tool(s): JLR-204-809
2. NOTE: Make sure that the component is installed to the noted removal position.
- Special Tool(s): JLR-204-810
- General Equipment: Hydraulic press
3.
4.
- Special Tool(s): 204-726
- General Equipment: Hydraulic press
5. Refer to: Wheel Knuckle (204-02 Rear Suspension, Removal and Installation).
READ NEXT:
Front Lower Arm
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Front wheel drive transmission illustrations shown, all wheel wheel drive
transmission
Rear Lower Arm AWD
Special Tool(s)
205-857
Remover, Halfshaft
Removal
CAUTION: LH illustration shown, RH is similar.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
Rear Stabilizer Bar
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure
SEE MORE:
Climate
Control Module (HVAC)
Heating Ventilation Air Conditioning Module (HVAC)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
&nbs
Rear Halfshaft LH
Special Tool(s)
205-857
Remover, Halfshaft
205-928
Remover, Half Shaft Inboard Joint
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft con
