Range Rover Evoque: Intake Manifold

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol / Intake Manifold

Removal

NOTES:

Removal steps in this procedure may contain installation details.

Some illustrations may show the engine removed for clarity.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

Range Rover Evoque. Engine - GTDi 2.0L Petrol

10.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

11. NOTE: Do not disassemble further if the component is removed for access only. Torque: 8 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

12.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

13. Torque: 5 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. To install, reverse the removal procedure.

2. CAUTIONS:

Tighten the bolts in the sequence shown.

Make sure that the mating faces are clean and free of foreign material.

Torque: 20 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

SEE MORE:

Headlamps

Principle of Operation Three types of headlamp are available: Halogen, bi-xenon or Adaptive Front Lighting System (AFS). For a detailed description of the headlamps operation, refer to the relevant Description and Operation section of the workshop manual. REFER to: (417-01 Exterior Lighting) Give

Installing an isofix child seat

Installing an isofix child seat To install an ISOFIX child seat: 1. Locate the ISOFIX locking mechanism. 2. Slide the child seat into the locking mechanism. 3. If an upper tether is fitted to the child seat, ensure it is properly secured to the upper tether anchorages on the rear of the sea

Range Rover Evoque: Intake Manifold

READ NEXT:

Oil Cooler

Oil Pan

Oil Pump

SEE MORE:

Headlamps

Installing an isofix child seat