Range Rover Evoque: Engine - GTDi 2.0L Petrol
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol
- Engine - Component Location, System Operation and Component Description
- Engine Oil Draining and Filling, Camshafts
- Cylinder Head
- Engine Mount LH/RH
- Intake Manifold
- Oil Cooler
- Oil Pan
- Oil Pump
- Timing Chain
- Timing Cover
- Valve Cover
- Engine - Removal and Installation
- Engine Upper/Lower Support Insulator
- Oil Filter Housing
- Balance Shaft Assembly
- Engine - Diagnosis and Testing
- Engine Timing
READ NEXT:
Engine - Component Location, System Operation and Component
Description
Component Location
EXTERNAL VIEW
Overview
OVERVIEW
The 2.0L Gasoline Turbocharged Direct Injection (GTDi) engine is an in-line,
double overhead camshaft, 4 cylinder engine,
which is transverse mount
Cylinder Block Components - 2.0L GTDi
Component Description
Front crankshaft oil seal
Front cover assembly
Knock sensor - cylinders 1 and 2
Gasket - thermostat housing
Thermostat
Cylinder block
Knock sensor - cylinders 3 and 4
B
Cylinder Head Components - 2.0L GTDi
Component Description
Oil level gage
Spark plug (4 off)
Variable valve timing solenoid valve - Inlet camshaft
Variable valve timing solenoid valve - Exhaust camshaft
Ignition coil and plug cap
SEE MORE:
Floor Console Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on
both sides.
NOTE: LH illustration shown, RH is similar.
Torque: 1.9 Nm
Vehicles with manual transmission
2. Refer to: Gearshift Lever Knob (308-06 Manual
Tr
Set or increase cruise speed
When setting the cruise
control to the
speed limit, it is important to remember
that it is possible for the vehicle speed
to increase when travelling downhill.
This may result in the vehicle speed
exceeding the speed limit.
Note: Cruise control can be engaged only at
speeds in excess of 30
© 2011-2025 Copyright www.rrevoque.org
