Range Rover Evoque: Switching off the engine

Before switching off the engine, ensure that the vehicle is parked safely with the park brake applied.

1. Select P for automatic transmission, or neutral for manual transmissions.

Note: If any other gear is selected at switch off, the rotary selector will automatically move to P before retracting into the centre console.

2. Press the START/STOP button.

Note: The park brake will apply automatically if it has not already been applied.

READ NEXT:

 Switching off the engine with the vehicle moving

It is not advisable to switch off the engine while the vehicle is moving. However, should such a situation arise, then the following procedure applies. - Press and hold the engine START/STOP

 Rolling re-start

If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated. Automatic transmission - select neutral (N) and then press the engine START/STOP button. When the en

 Keyless start backup

If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start t

SEE MORE:

 Rear Side Member Section

Removal NOTES: The rear side member section is manufactured from RP260, with its inner reinforcement manufactured from DP600. The rear side member section is cut from the rear side member service panel, the section also includes the upper and lower side extensions. 1. In this procedure, to make s

 Trailer electrical connection

Connect only approved electrical circuits, which are in good condition, to the trailer socket. The vehicle connector provides a 5 amp output which must not be exceeded. An accessory harness kit increasing output to 15 amp is available from your Land Rover Dealer. When a trailer electrica

© 2011-2025 Copyright www.rrevoque.org