Range Rover Evoque: General program (special programs off)

This program is compatible with all

This program is compatible with all on and off-road conditions. If not already active, it should be selected before driving on surfaces which are similar to a hard road surface. Dry cobbles, tarmac, dry wooden planks, etc., all fall into this category.

This program should be selected once the need for a special program has passed. Once the special program has been deselected, all of the vehicle systems will return to their normal settings except HDC. HDC will remain active if it was selected manually.

READ NEXT:

 Grass-gravel-snow

This program should be used where a firm surface is covered with loose or slippery material. Note: For deep snow it is recommended that the Sand program is selected. Note: If the vehicle is una

 Mud-ruts

This program should be used for crossing terrain that is muddy, rutted, soft or uneven. HDC is automatically selected with this program.

 Sand

This program should be used for terrain which is predominantly soft dry sand or deep gravel. Note: If the vehicle is unable to gain traction in extremely soft, dry sand, switching DSC off may h

SEE MORE:

  Hill descent control (HDC) controls

Hill descent control (HDC) controls 1. Press to switch HDC on and off. 2. Press to increase the set speed. 3. Press to decrease the set speed. Manual transmission: HDC can be used in 1st, 2nd or reverse gears. Automatic transmission: HDC can be used in D, R and CommandShift 1, 2 or 3. Note

  Hdc operation

With HDC engaged, standard descent speed will not exceed 20km/h (12.4mph). While the green warning lamp is continuously illuminated, HDC target speed can be modified using the cruise control steering wheel switches, as follows: - To increase speed, press and hold switch (2) until the green po

© 2011-2026 Copyright www.rrevoque.org - 0.0046