Range Rover Evoque: Suspending and resuming cruise control
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Cruise control / Suspending and resuming cruise control
Suspend cruise control with a single press of control (3).
To resume cruise control at the previous set speed, press control (2).
RES (2) should be used only
if the
driver is aware of the set speed and
intends to return to it.
It is not recommended to resume set
speed when a low gear is selected as
excessive engine speeds will occur.
READ NEXT:
Automatic switch off
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park
Cruise eco data
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH
SEE MORE:
Using cruise control
Using cruise control
1. Set target speed, or increase speed.
2. RES. Resume set speed.
3. CAN. Suspends cruise control operation
without erasing memorised speed.
4. Decrease set speed.
Note: Cruise control is not available when
using Hill Descent Control or when a Terrain
Response special
Set or increase cruise speed
When setting the cruise
control to the
speed limit, it is important to remember
that it is possible for the vehicle speed
to increase when travelling downhill.
This may result in the vehicle speed
exceeding the speed limit.
Note: Cruise control can be engaged only at
speeds in excess of 30
© 2011-2026 Copyright www.rrevoque.org - 0.0054
