Range Rover Evoque: Using cruise control

Using cruise control
1. Set target speed, or increase speed.
2. RES. Resume set speed.
3. CAN. Suspends cruise control operation
without erasing memorised speed.
4. Decrease set speed.
Note: Cruise control is not available when
using Hill Descent Control or when a Terrain
Response special program has been selected.
Note: Do not use cruise control when driving
off-road.
READ NEXT:
When setting the cruise
control to the
speed limit, it is important to remember
that it is possible for the vehicle speed
to increase when travelling downhill.
This may result in the vehicle sp
To reduce cruising speed, press and hold
control (4). Release the switch when the
desired speed is reached, the new speed will be
set and maintained.
The set speed can be decreased in steps of
2k
Suspend cruise control with a single press of
control (3).
To resume cruise control at the previous set
speed, press control (2).
RES (2) should be used only
if the
driver is aware of the set
SEE MORE:
Removal
1. Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation,
Removal and Installation).
2.
3.
4. CAUTION: The step must be carried out on both
sides.
5. CAUTIONS:
Protect the surrounding components.
Protect the surrounding paintwork to avoid
damage.
Use a glazing cutting wire to
Removal
CAUTIONS:
Always protect paintwork and glass when removing exterior components.
Always protect the interior components when removing body glass.
Lay the glass on felt covered supports. Do not stand on edge as this can cause
chips which subsequently develop
into cracks.
NOTES:
The cutting
© 2011-2026 Copyright www.rrevoque.org - 0.0035
