Range Rover Evoque: Electronic Engine Controls - System Operation and Component Description
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Electronic Engine Controls - GTDi 2.0L Petrol / Electronic Engine Controls - System Operation
and Component Description
READ NEXT:
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High Speed CAN Bus; O = Local Interconnect
Network (LIN) Bus
CONTROL DIAGRAM - SHEET 1 OF 2
Battery
Starter motor fuse
Battery Junction Box (BJB)
Starte
Component Description
DESCRIPTION
Engine Control Module (ECM)
The ECM is located at the rear of the engine compartment, between the
bulkhead and the engine sound insulation. The ECM is located in a plastic molded
carrier
Crankshaft Position (CKP)
Sensor
Special Tool(s)
303-1390A
CKP Sensor Alignment Tool
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure
SEE MORE:
Emission control system
Land Rover vehicles are fitted with emission
and evaporative control systems. In many
countries it is unlawful to tamper, modify or
replace such equipment and legal penalties
apply if the laws are flouted.
Land Rover Dealers/Authorised Repairers are
properly equipped to perform repairs and to
Tyre care
Do not drive the vehicle if a
tyre is
damaged, excessively worn, or
incorrectly inflated.
Avoid contaminating the tyres with
vehicle fluids as they may cause
damage to the tyre.
Avoid spinning the wheels. The forces
released can damage the structure of
the tyre and cause it to fail.
If w
© 2011-2026 Copyright www.rrevoque.org
