Range Rover Evoque: Evaporator LHD
Removal
NOTES: The removal of this component involves cutting an aperture in the evaporator housing wall and cutting through the high and low pressure A/C lines. A service repair kit is supplied to cover this procedure.
Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - GTDi 2.0L Petrol (412-00 Climate Control System - General Information, General Procedures).
Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - TD4 2.2L Diesel (412-00 Climate Control System - General Information, General Procedures).
3. Refer to: Plenum Chamber (412-01 Climate Control, Removal and Installation).
4. Refer to: Central Junction Box (CJB) (418-00 Module Communications Network, Removal and Installation).
5. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
6.
7. Torque: 10 Nm
8. CAUTIONS: Make sure that all openings are sealed. Use new blanking caps.
Lubricate the new seals with clean refrigerant oil.
NOTE: Install new O-ring seals.
Torque: 9 Nm
9. Torque: 4 Nm
10. NOTE: LH illustration shown, RH is similar.
11.
12.
13.
14.
15.
16. Torque: 10 Nm
17.
18.
19.
20.
21.
22.
23.
24.
25. CAUTION: Make sure that the area around the component is clean and free of foreign material.
Installation
1. Apply the foam strips from the service kit to the evaporator core.
2.
3.
4. NOTE: Install new O-ring seals.
Torque: 5 Nm
5. To install, reverse the removal procedure.
READ NEXT:
Evaporator RHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to c
Evaporator Temperature Sensor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Condenser TD4 2.2L Diesel
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur
SEE MORE:
Hdc operation
With HDC engaged, standard descent speed
will not exceed 20km/h (12.4mph).
While the green warning lamp is continuously
illuminated, HDC target speed can be modified
using the cruise control steering wheel
switches, as follows:
- To increase speed, press and hold switch
(2) until the green po
Front Inner Quarter Panel
Removal
NOTES:
The front inner quarter panel is manufactured from mild steel.
The front inner quarter panel is to be unpicked from the inner quarter panel, it
is not serviced separately.
There are NVH components on this panel, they are not serviced on the new panel.
If damaged, new components wi
