Range Rover Evoque: Climate Control System
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Climate Control System
- Climate Control System - General Information
- Climate Control
- Air Distribution and Filtering
- Heating and Ventilation
- Air Conditioning
- Control Components - Component Location
- Control Components - System Operation and Component Description
- Condenser GTDi 2.0L Petrol
- Blower Motor LHD AWD/LHD FWD
- Blower Motor RHD AWD/RHD FWD, RHD
- Climate Control Assembly
- Evaporator LHD
- Evaporator RHD
- Evaporator Temperature Sensor
- Condenser TD4 2.2L Diesel
- Heater Core and Evaporator Core Housing
- Defrost Vent/Register Blend Door Actuator LHD AWD/LHD FWD
- Desiccant Bag GTDi 2.0L Petrol
- Control Components FWD - Overview
- Auxiliary Climate Control
READ NEXT:
Climate Control System - General Information
Climate Control
Lubricants, Fluids, Sealers and Adhesives
General Specification
Capacities
Refrigerant oil adding capacities for replacment parts
NOTE: Rotate the A/C compressor shaft at least 6 t
Air Distribution and Filtering
Component Location
NOTE: Right Hand Drive (RHD) shown, Left Hand Drive (LHD) similar
COMPONENT LOCATION
Passenger face level/side window register
Side window vent
Face level duct
Side window duc
SEE MORE:
Engine Mount LH/RH
Engine Mount LH
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
S
Epb automatic use
EPB will be applied automatically if the ignition
is switched off and the vehicle speed is below
3km/h (2mph).
To prevent automatic operation, when the
vehicle is stationary, press and hold the EPB
switch in the release position. Within 5
seconds, switch off the ignition and continue to
hold
© 2011-2026 Copyright www.rrevoque.org
