Principle of Operation
For a detailed description of the locks, latches and entry systems and
operation, refer to the relevant Description and
Operation section of the workshop manual REFER to: Handl
Control Diagram
NOTE: A = Hardwired; F = RF transmission; N = Medium speed CAN (controller
area network) bus; O = LIN (local
interconnect network) bus.
Instrument cluster
CJB (central junction bo
Special Tool(s)
205-857
Remover, Halfshaft
205-928
Remover, Half Shaft Inboard Joint
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft con
Special Tool(s)
303-D121
Puller, General Purpose
General Equipment
Vise
Removal
NOTE: RH inner constant velocity joint boot shown, LH is similar.
1. Refer to: Front Halfshaft LH (205-04 Front Drive Halfshafts, Removal
and Installation).
Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Fron