Range Rover Evoque: Rolling re-start
If the engine is switched off while the vehicle is
moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and
then press the engine START/STOP button.
When the engine re-starts, select transmission
position D.
Manual transmission - depress the clutch and
then press the engine START/STOP button.
When the engine re-starts, select an
appropriate forward gear.
READ NEXT:
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start t
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst
The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not re
SEE MORE:
Component Location
COMPONENT LOCATION
High pressure line
Low pressure servicing connection
High pressure servicing connection
Thermostatic expansion valve
Evaporator
Refrigerant pressure sensor
Receiver/Drier
Condenser
A/C (air conditioning) compressor
Low pressure line
COMPONENT LOCATI
Prior to checking the oil level ensure that:
- The vehicle is on level ground.
- The engine oil is cold.
Note: If it is necessary to check the oil level
when the engine is hot, switch off the engine
and let the vehicle stand for 5 minutes to allow
the oil to drain back into the sump. Do not st
© 2011-2025 Copyright www.rrevoque.org
