Range Rover Evoque: Oil Cooler

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol / Oil Cooler

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).

4. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L Petrol, General Procedures).

5. Refer to: Engine Cover - GTDi 2 0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7. CAUTION: Make sure that the area around the component is clean and free of foreign material.

Torque: 22 Nm
Torque: 75

SEE MORE:

Transfer Case Fluid Level Check

CAUTION: The fluid filler plug is not a fluid level plug. NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Engine Undershield (501-02 Fron

Electronic Engine Controls

Principles of Operation For a detailed description of the 2.0L GTDi petrol electronic engine controls, refer to the relevant Description and Operation section in the workshop manual. REFER to: (303-14B Electronic Engine Controls - GTDi 2.0L Petrol) Inspection and Verification CAUTION: Diagnosis by

Range Rover Evoque: Oil Cooler

READ NEXT:

Oil Pan

Oil Pump

Timing Chain

SEE MORE:

Transfer Case Fluid Level Check

Electronic Engine Controls