Range Rover Evoque: Engine
- Engine System - General Information
- Engine - GTDi 2.0L Petrol
- Engine - Component Location, System Operation and Component Description
- Engine Oil Draining and Filling, Camshafts
- Cylinder Head
- Engine Mount LH/RH
- Intake Manifold
- Oil Cooler
- Oil Pan
- Oil Pump
- Timing Chain
- Timing Cover
- Valve Cover
- Engine - Removal and Installation
- Engine Upper/Lower Support Insulator
- Oil Filter Housing
- Balance Shaft Assembly
- Engine - Diagnosis and Testing
- Engine Timing
- Engine Cooling - GTDi 2.0L Petrol
- Engine Cooling - Component Location, System Operation and Component Description
- Cooling System Draining, Filling and Bleeding
- Radiator
- Cooling Fan
- Cooling System Partial Draining, Filling and Bleeding
- Engine Cooling - Diagnosis and Testing
- Block Heater
- Fuel Charging and Controls - GTDi 2.0L Petrol
- Fuel Charging and Controls - Component Location, System Operation and Component Description
- Throttle Body
- Fuel Rail
- Fuel Pump
- Fuel Charging and Controls - Turbocharger - GTDi 2.0L Petrol
- Accessory Drive - GTDi 2.0L Petrol
- Starting System - GTDi 2.0L Petrol
- Engine Ignition - GTDi 2.0L Petrol
- Engine Emission Control - GTDi 2.0L Petrol
- Intake Air Distribution and Filtering - GTDi 2.0L Petrol
- Evaporative Emissions - GTDi 2.0L Petrol
- Electronic Engine Controls - GTDi 2.0L Petrol
READ NEXT:
Engine System - General Information
Cylinder Head Gasket Selection TD4
2.2L Diesel
Special Tool(s)
303-979
Measuring Bridge, Piston Protusion
1. CAUTION: Make sure that the surface is clean and
free of foreign material.
Zero the gauge o
Engine - Component Location, System Operation and Component
Description
Component Location
EXTERNAL VIEW
Overview
OVERVIEW
The 2.0L Gasoline Turbocharged Direct Injection (GTDi) engine is an in-line,
double overhead camshaft, 4 cylinder engine,
which is transverse mount
SEE MORE:
Crankshaft Position (CKP)
Sensor
Special Tool(s)
303-1390A
CKP Sensor Alignment Tool
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Wheel and Tire
Rear Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm
2. Torque: 6 Nm
3. Torque: 6 Nm
4.
5.
6.
7. NOTE: Do not disassemble further if the
component is removed for access only.
8. Torque: 0.6 Nm
9.
10. Torque: 1 Nm
11.
Installation
1. To install,
© 2011-2026 Copyright www.rrevoque.org
