Range Rover Evoque: Electronic Engine Controls - GTDi 2.0L Petrol
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Electronic Engine Controls - GTDi 2.0L Petrol
- Electronic Engine Controls - Component Location
- Electronic Engine Controls - System Operation and Component Description
- Crankshaft Position (CKP) Sensor
- Catalyst Monitor Sensor
- Electronic Engine Controls
READ NEXT:
Electronic Engine Controls -
Component Location
Component Location
COMPONENT LOCATION - SHEET 1 OF 4
Fuel metering valve - HP Fuel pump
Camshaft Position (CMP) sensor (2 off)
Variable Camshaft Timing (VCT) solenoid (2 off)
Purge valve
Genera
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High Speed CAN Bus; O = Local Interconnect
Network (LIN) Bus
CONTROL DIAGRAM - SHEET 1 OF 2
Battery
Starter motor fuse
Battery Junction Box (BJB)
Starte
SEE MORE:
Suspension Top Mount
Removal
NOTES:
The suspension top mount is manufactured from mild steel and RP220.
The service panel is serviced not fully spot welded.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2.
Front Side Member Section
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member section is cut from the front side member and is
manufactured from RP260.
This procedure is written for the LH front side member section replacement, the
LH and RH front side member sections differ i
© 2011-2026 Copyright www.rrevoque.org - 0.0071
