Range Rover Evoque: Desiccant Bag GTDi 2.0L Petrol

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Condenser - GTDi 2.0L Petrol (412-01 Climate Control, Removal and Installation).

3. Torque: 11 Nm

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

Desiccant Bag TD4 2.2L Diesel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.

2. Refer to: Condenser - TD4 2.2L Diesel (412-01 Climate Control, Removal and Installation).

3. Torque: 11 Nm

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

Heater Core GTDi 2.0L Petrol

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).

3. Refer to: Electric Booster Heater (412-02 Auxiliary Climate Control, Removal and Installation).

4. CAUTION: Be prepared to collect escaping coolant.

Range Rover Evoque. Climate Control

5.

Range Rover Evoque. Climate Control

6. CAUTION: Be prepared to collect escaping coolant.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

Thermostatic Expansion Valve GTDi 2.0L Petrol

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - GTDi 2.0L Petrol (412-00 Climate Control System - General Information, General Procedures).

3. Refer to: Engine Control Module (ECM) (303-14B Electronic Engine Controls - GTDi 2.0L Petrol, Removal and Installation).

4. CAUTIONS: Make sure that all openings are sealed. Use new blanking caps.

Lubricate the new seals with clean refrigerant oil.

NOTE: Install new O-ring seals.

Torque: 9 Nm

Range Rover Evoque. Climate Control

5. Torque: 4 Nm

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

Blower Motor Resistor RHD AWD/RHD FWD

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. NOTE: LHD illustration shown, RHD is similar.

Range Rover Evoque. Climate Control

3. NOTE: LHD illustration shown, RHD is similar.

Range Rover Evoque. Climate Control

4.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

Footwell Vent/Duct Blend Door Actuator RHD AWD/RHD FWD

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Glove Compartment (501-12 Instrument Panel and Console, Removal and Installation).

3.

Range Rover Evoque. Climate Control

4.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.

Temperature Blend Door Actuator LH RHD AWD/RHD FWD

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Glove Compartment (501-12 Instrument Panel and Console, Removal and Installation).

3.

Range Rover Evoque. Climate Control

4.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.

Defrost Vent/Register Blend Door Actuator RHD AWD/RHD FWD

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Make the SRS system safe.

Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).

2. Refer to: Steering Column (211-04 Steering Column, Removal and Installation).

3.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.

READ NEXT:

 Control Components FWD - Overview

OVERVIEW The climate control system incorporates the heating, ventilation and A/C (air conditioning) systems. There are 2 main types of climate control system available: a dual zone automatic syste

 Auxiliary Climate Control

 Electric Booster Heater - Description and Operation

Component Location COMPONENT LOCATION Heater assembly Electric booster heater Overview OVERVIEW Due to the slower warm up times associated with the diesel engine, an electric booster heater may

SEE MORE:

 Transfer Case Seal RH GTDi 2.0L Petrol

Special Tool(s) 100-012 Slide Hammer 205-872 Installer, Transfer Case Seal 308-615 Remover, Seals 308-617 Depth Drill, Seal Remover Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is alway

 Body Repairs - Vehicle Specific Information and Tolerance Checks

Body and Frame Front End Body Dimensions NOTES: All dimensions shown are in millimetres (mm). Dimensions shown to holes, are always taken from/to the hole centre. They are also always to the body panel surface, not to the top of bolts or components. Side Panel Dimensions 3-door version 5-d

© 2011-2025 Copyright www.rrevoque.org